|
|
|
|
|
|
|
|
|
|
|
|
|
|
| WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations. |
|
| The Q&A on this Product |
|
|
| QUESTION: Hi Jolene.
The PO5 is a brembo caliper that was fitted to Italian motorcycles in the late 1970s and early 1980s such as the Laverda 500, Moto Guzzi V50 and Ducati 500 Pantah. They were also fitted to Yamaha TZR250s. The pistons are made of steel; are 32mm in diameter and 16mm deep. The side of the pistons is chrome plated, but after 30 years the chrome starts to lift and seals fail.
I have been able to find Brembo 32mm seals kits, and a repair kit for the master cylinder, but the pistons are a problem as Brembo stopped making the PO5 years ago and they don't make spare pistons anymore. However, I see that Brembo do make modern calipers with 32mm pistons. I thought it would be easy to find a match! Can you help? I need left and right.
Many thanks
Martin
|
| ANSWER: Can you please call me at 888.235.0910? I think it would help if we could talk. |
|
| QUESTION: Thank you. In order to replace the PO5, which calpier do you recommend?
Regards
Martin
|
| ANSWER: What is the PO5? Do you mean P105? Or maybe the FO5? The 20.5161.86 is a P32F and ytou can use it to replace the P105. The P32F comes in black, silver of gold. Are you looking for a right or left hand side?
Thanks,
Jolene |
|
| QUESTION: I need to replace the 32mm pistons on my PO5 Brembo calpiers. They are from a Laverda 500. Can you help? The pistons are 32mm diameter and 16mm deep. I need 6. Many thanks. |
| ANSWER: This caliper does not have a repair kit available. You will need to replace the entire caliper. |
|
| QUESTION: Do you have a BREMBO rear caliper that will bolt on to the stock hanger on my 2005 GSXR 1000? Thanks. |
| ANSWER: No, Brembo works with the European bikes. If there is a caliper you wish to use on the rear of your bike you will need to make your own bracket to make it work. |
|
|
|
| Ask your question here: |
|
| Your email (so we can send you the answer): |
|
|
|
Event Schedule
powered by WordPress e-commerce company