|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Can’t find a matching part number? Find the piston size of your unit. Front Master Cylinders - check the top or bottom of the lever clevis for a stamped alphanumeric string. The last two digits in the string indicate the piston size in mm (EXAMPLE: ‘1PJK 15’ = 15mm piston. In the case of ‘Radial-GP’ pumps, you may see a ‘PR’ or ‘/’’ stamping, followed by a number. If the number is “19x18” or “16x18”, the first number is piston size, the second refers to the pivot centers of the unit’s lever). Rear Master Cylinders - for lever-types, check clevis area as above. If rod-actuated, check the entire body for the alphanumeric string or a string starting with ‘PS’ (EXAMPLE: ‘PS12’ = 12mm piston). |
|
|
| WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations. |
|
| The Q&A on this Product |
|
|
| QUESTION: With the 10.8210.10 unit being for the brake master, what's the matching clutch master since I can't find it on your website? |
| ANSWER: 10.8101.10 is the clutch part number. The price is $333.16. Thank You, I will have 1tail put the part on their site.
Jolene |
|
| QUESTION: I want a high pressure (output) master cylinder. I have only a single caliper. Will this accommodate a single hose to a single caliper? If not, and this model is only for dual calipers, please recommend an equal high pressure model for a single caliper. Thanks. |
| ANSWER: I would reccommend tthe 16 x 18 radial master cyclinder part number 10.4760.85.
It is a remote reservoir so you will have to get that seperately. THe radial master cylinder will give you the best performance and value.
Thanks you,
Jolene |
|
| QUESTION: Do you sell a rebuild kit for this master cylinder? |
| ANSWER: It has kits for everything but the piston and seal kit available. You need to replace the whole unit if this is the problem. Thanks! |
|
| QUESTION: what is the finish on this and will it fit 1" bars? |
| ANSWER: Finish is anodized aluminum and it will NOT fit 1" bars. |
|
| QUESTION: does the 18/19 mean this is a 18mm bore unit? |
| ANSWER: Yes, this is an 18mm bore unit. |
|
| QUESTION: Is item 10.8210.10 come complet with the lever and reservoir.
Same ? for the clutch side. |
| ANSWER: Yes it does and the clutch side too.
|
|
| QUESTION: Is there a cable cable clutch lever setup that is available to match the 10.8210.10? I just need the levers to match. Aftermarket levers CRG Roll-a-Click Folding Lever and GP Clutch/Perch Lever are totally acceptable if they will apply. I'm not sure. I could use some help. Simple is good, clean is great! |
| ANSWER: What you are looking for as far as I know is not available. At least not from Brembo. Thanks, Jolene |
|
|
|
| Ask your question here: |
|
| Your email (so we can send you the answer): |
|
|
|
Event Schedule
powered by